Epoxy Floors Applicators East-Northport Long Island NY.Epoxy Floors Installers Experts This epoxy floor was installed in a private residence in East Northport long island NY The product applied was Purepoxy products EZ Concrete Supply NY.
First step was the grinding of the floor, to remove the existing asbestos tiles and the asphalt tar used to glue them to the concrete, special diamond blade capable of removing paint and scarifying the concrete to create a textured evenly and abrasive ready for the epoxy VRM Vapor reduction * PE -100 pigmented Tan membrane to stick to it.
Saddle Tan Colored Chips Broadcasted in to the epoxy Base while wet and then let is dry for 24 hours. After the epoxy is cured the access vinyl flakes were removed and floor vacuumed. A final coat of PE-100 Clear Top Coated the flakes totally covering them and giving the floor a very smooth texture finish.
Normally a coat of urethane finish is applied to further hardening the epoxy finish and also protect it from UV lights , mostly in vehicular trafficated areas, but in this case being in a basement there is no need to apply urethane because the floor in only used for kids playground and laundry room.
Best Epoxy Floors Applicators and Experts, Epoxy Floors Applicators East-Northport Long Island NY
The construction of the vinyl swimming pool concrete walls consisted of assembling aluminum molds while after the walls are then poured, reinforced with rebar. The pool floor base was made with dry-pack sand and cement materials to harden and avoided foot prints. One large light was installed in the deep end and one small light was installed in the shallow area. The pool also had two wide-mouth skimmers encased in the concrete walls along with four returns and two deep end bottom drains.
Pool house pavilion/garage combination built in Dix Hills, NY with cedar shake shingles impression vinyl siding and 30 year architectural brown shingles. Part of the structure has a garage door to the driveway and an overhanging pavilion facing the pool and backyard. The garage was built with extra height to accommodate a car lift. Trim and columns were finished with Azek, masonry piers and BBQ island, with a grill refrigerator and bar sink, constructed with Moca travertine veneers. The large free form swimming pool was built with concrete walls and a liner, a shallow deep end to accommodate the SRS Slide, 3 sheer descents built in the raised wall on the back side of the pool, concrete steps covered with a textured liner, a deep end bench, a standing ledge, an LED light, gas heater, salt water chlorine system, and full automation. Approximately 3,000 sq ft of Moca travertine pavers were used for the entire backyard, and the deck leading to the house was constructed with Timbertech. To learn more about Gappsi Products please follow our blog 
Designed by Giuseppe Abbrancati and installed by Gappsi, this swimming pool patio displays Winter Cream marble pavers from Bay Rock suppliers. A primary white marble with a smooth textured, semi-polished finish and tumbled edges. The pool coping is also polished winter cream marble. A raised patio area was built with columns on each side including spillover water bowls. These water bowls are made of a transparent resin that allows the light that is inside of the bowl to come through. The red light inside the spill over bowl is made to mimic fire, creating a very impressive special effect. The sun deck also incorporates a sheer descent with wall washer lights mounted underneath the coping of the sun deck, steps, and columns.