Custom Built Fountain By Gappsi In East Islip NY

Custom Built Fountain By Gappsi In East Islip NYConstructed with a 14 ft wide diameter and 18 inches deep gunite pool, with a custom sized pedestal shaped with the gunite shell to support and raise above water level the brass Four seasons statue. Brick veneer was installed to cover the outside pool wall and a custom bluestone coping was installed on top of the fountain wall. Inside was finished with Black diamond bright quartz finish. The LED lights were installed on underwater illuminating the pool and shining up to the statue as well. Pentair equipment were used for Water circulation returning water to the top of the statue  creating a free fall spill over on all sides, UV light sanitation system was also installed to keep the water sanitized

Share this page:

Safety Mesh Winter Pool Covers – Installers & Specialists – Long Island, NY

Safety Mesh Winter Pool Covers - Installers & Specialists - Long Island, NYMesh covers are the most common way to safeguard your pool during the winter. A winter cover has to be strong and made of good quality material. There are many manufactures of pool liners and mesh safety covers, and mesh covers can be ordered according to the initial pool liner measurements.
Gappsi can supply and install a mesh pool cover, we are authorized dealers and installers for every brand, from Loop-Loc, Merlin, Lathem, Vynall and many other others.
Manufactures make many grades of covers, the better the grade the more expensive to cover is. Tight thin mesh and strong fibers used to manufacture the covers will give your pool cover the quality to last for many years.
Swimming pool winter covers installed by Gappsi will give you all the protection, security, and safety you need for your family, pets, and neighbors. Winter pool covers are manufactured to let the water from the rain drain through. Also, it allows you to put your pump in the middle of the cover and allow the extra water in the pool to come through and get pumped out. Winter covers are manufactured in all mesh or solid rubber with a 24×24 mesh hole in the center to let water drain into the pool. Anchors are installed in the patio about 36 inches away from the swimming pool. The way they are installed is by drilling a hole in the patio, brass anchors are slid through, and the cover is then attached to the anchors. If the patio is not installed correctly, the cover may become loose and it will not be as safe as it should be.
The Gappsi way of installation starts with the proper installation of the patio. Four foot wide slabs with reinforced rebar are always installed around the swimming pool to prevent settling of the patio, then the finished paving material is installed over the concrete base. The Gappsi installation of the safety pool cover is then installed over the patio by drilling holes straight through the finished paving material all the way down into the concrete base. A sleeve is installed into the hole about 6 inches into the patio going through the 4 inches of concrete base and further in the ground, and a brass screw pin is then installed into the pipe. By unscrewing the brass screw pin; it comes up above the patio and allows for the cover ring hooks to attach to the brass screw. After this is all done for every strap of the cover, your Gappsi installed pool cover is safe to walk on with no chance of breaking.

Winter Safety Mesh Covers Installer companies Long Island

Share this page: